0723u – Nu Trac

the digging of this whole was a saga which I have narrated elsewhere

Comment on Bose Wave Radio/CD – quick repair by Richard November 16, 2017

In reply to Vikki. Best not to work with electricity if you are not sure what you are doing.

Comment on Bose Wave Radio/CD – quick repair by Richard November 16, 2017

In reply to Vivian Doherty. I think it will be expensive and probably not worth it since something else may fail later. Try getting a free repair quote.

Comment on Bose Wave Radio/CD – quick repair by Richard November 16, 2017

In reply to Stutely. I forget, probably 15 amps.

Comment on the Takeuchi bobcat saga (part 2) by Richard November 16, 2017

In reply to Dusty. Take a look at my Nov 25, 2014 post where I describe how I did it. The plate metal shield underneath must be removed.

Comment on the Takeuchi bobcat saga (part 2) by Dusty November 16, 2017

I'm putting a new starter in my TL-140 2005 does anyone have any comments on how to go about it

Comment on Bose Wave Radio/CD – quick repair by Stutely November 16, 2017

What size fuse did you end up using?

Comment on Bose Wave Radio/CD – quick repair by Vivian Doherty November 4, 2017

My Bose with multi cd changer won't work anymore after a power outage. Its about 10 yrs old the Clock works but it also reads wait for radio but then goes out. When I unplug it then replug it in , the cd player lights up ejecting the cds then after nothing happens. I would […]

Comment on Bose Wave Radio/CD – quick repair by Vikki November 4, 2017

In reply to Richard. Thank you for this post. Mine also completely quit working after a power surge, and stupidly no surge protector. As I am clueless, will look around for an electronics repair shop in my area and hope for a blown fuse.

Comment on Takeuchi electrical starting problems by jarrod October 17, 2017

Got it, there were two smaller red wire that were loose and corroded on the positive battery cable where they attach to the battery. couldn't see the damage as there was some heat shrink on them. but they were getting hot when we were trying to start it, do to poor connection, so that's how […]

Comment on Takeuchi electrical starting problems by Richard October 16, 2017

In reply to jarrod. Thanks for your detailed post. I created the detailed post so I could retrace my steps if problems recurred. I do describe the safety relay in steps 4, 5 and 7 and provide specs for the wires which go to it. You should be able to locate it. You will notice […]

Leave a Reply Cancel reply